Single Car Control through one Hand Controller
The normal procedure for programming is to remove all cars from the track.
Place the car to be programmed on the track and press the program ID button (buttons found on the powerbase, just above where the hand controllers are plugged in). This car is now programmed with the specified ID.
Repeat this operation for any other cars that need an ID set and, of course, use the appropriate ID number for each car.
All other programmed cars can now be replaced on the track. Racing can commence.
Multi-Car Control through one Hand Controller
One controller can be used to control more than one car simultaneously.
Place the cars to be controlled by one controller on to the track. Set the ID button. These cars will now operate under the control of the hand controller.